如何在Windows 10中用XAMPP安装Typo3？及相关报错解决求助

Let’s work through your three stubborn issues step by step—all of them can be resolved by adjusting your XAMPP PHP configuration. Here’s what to do for each:

1. PHP OpenSSL Extension Not Working #

• Locate your XAMPP PHP configuration file: it’s usually at C:\xampp\php\php.ini (adjust the drive letter if your XAMPP is installed elsewhere). Open it with a text editor like Notepad++ (regular Notepad works too, just avoid word processors).
• Search for the line ;extension=openssl. Remove the leading semicolon (;) to uncomment it, so it reads:

  extension=openssl
  

• Next, verify the extension_dir setting. Look for:

  extension_dir = "ext"
  

  If it’s commented out or uses an incorrect path, update it to the absolute path of your PHP extensions folder (e.g., extension_dir = "C:\xampp\php\ext").
• Save the php.ini file, then restart your Apache server via the XAMPP Control Panel (click Stop, then Start).
• To confirm it’s working: Create a file named phpinfo.php in C:\xampp\htdocs with this content:

  <?php phpinfo(); ?>
  

  Visit http://localhost/phpinfo.php in your browser, search for "OpenSSL"—you should see a section showing the extension is enabled.

2. PHP SOAP Extension Not Loaded #

This fix follows a similar pattern to the OpenSSL issue:

• Open C:\xampp\php\php.ini again.
• Find the line ;extension=soap and remove the leading semicolon to enable it:

  extension=soap
  

• Double-check that extension_dir is correctly set (as covered in the OpenSSL section).
• Save the file and restart Apache.
• Verify using phpinfo.php—search for "SOAP" to confirm the extension is active.

3. Current Directory Not in Path #

This refers to PHP’s include_path missing the current directory (denoted by .), which Typo3 requires:

• Open C:\xampp\php\php.ini.
• Locate the include_path line. It should look something like this by default:

  include_path = ".;C:\xampp\php\PEAR"
  

  If the . is missing, add it at the start (separated by a semicolon from other paths). For example, if it was include_path = "C:\xampp\php\PEAR", change it to:

  include_path = ".;C:\xampp\php\PEAR"
  

• Save the file and restart Apache.
• Confirm via phpinfo.php—search for "include_path" to ensure . is listed in the value.

Quick Notes #

• Always back up your original php.ini file before making changes, just in case you need to revert.
• If you’re using a 64-bit version of XAMPP, ensure you’re editing the correct php.ini (it should be in the php folder under your XAMPP root, not in any subfolders).
• After each change, restarting Apache is critical—PHP won’t pick up the new settings until the server is rebooted.

内容的提问来源于stack exchange，提问作者Karthik