如何在Oracle Data Integrator中将Load Plan步骤设为Fire and Forget

Got it! Setting up a Fire and Forget step for your standalone Procedure in an ODI Load Plan is super straightforward. Here's a step-by-step breakdown:

• Open your target Load Plan and navigate to the standalone Procedure step you want to modify.
• Right-click on the step and select Configure (or just double-click it to open the settings window).
• In the configuration window, switch to the Execution tab.
• Look for the Execution Mode dropdown menu, then select the Fire and Forget option.

  Quick note: Once you select this mode, ODI will kick off the Procedure's execution and immediately move on to the next steps in your Load Plan—no waiting around for it to finish.

• Double-check any other settings (like retry attempts or log level) if you need to adjust them, then hit OK to save the changes.
• Don't forget to save the entire Load Plan to make sure your new configuration takes effect.

A couple of quick reminders:

• Even though it's "fire and forget", the step's execution logs will still be available in ODI's monitoring tools, so you can check its status later if needed.
• Make sure this Procedure truly doesn't have any dependencies with other steps in your Load Plan—otherwise, you might run into data consistency issues down the line.

内容的提问来源于stack exchange，提问作者Srikar mogaliraju