关于1TB WD外置硬盘chkdsk /f/r/x命令卡在第二阶段12天能否终止的咨询

Hey there, let's work through this problem together—12 days stuck on chkdsk's Stage 2 is way outside the normal range, so I totally get why you're frustrated.

First, let's set some clear expectations: Stage 2 of chkdsk focuses on scanning the drive's directory structure, and with the /r flag enabled, it’s also trying to locate and recover data from bad sectors. Even for a 1TB drive loaded with 480GB of data, this process should never take 12 days—under worst-case scenarios (like a drive with scattered bad sectors), it might top out at 2-5 days max. The fact it’s been stuck this long tells me either the process is truly frozen, or your drive has severe hardware issues (like a massive cluster of unreadable bad sectors) that are making chkdsk loop indefinitely trying to recover data.

Now, to your core question: should you keep waiting, or abort?

• Waiting longer is almost certainly a waste of time. If you haven’t seen even tiny progress increments (like a moving progress bar or new command-line logs) in the last few days, the process is likely stuck. The blinking light might just be the drive doing idle read cycles, not actual chkdsk work.
• Aborting carries minor risk, but it’s manageable. Chkdsk is built to handle interruptions gracefully most of the time—there’s a small chance of minor file system corruption, but the risk of letting the drive’s condition worsen by waiting is far higher.

If you decide to abort, here’s a step-by-step plan:

• Don’t write anything to the drive yet. Avoid saving files, installing software, or running other repair tools until you’ve secured your data.
• Prioritize data recovery first. If your files are important, consider removing the drive from its enclosure (be careful with static electricity if it’s a 2.5-inch portable model) and connecting it directly to a desktop PC as a secondary drive. Use a data recovery tool to pull your critical files onto another healthy drive—this minimizes the risk of overwriting data on the faulty drive.
• Check the drive’s hardware health. Use WD’s official diagnostic tool (WD Drive Utilities) to scan for bad sectors or other hardware failures. If hardware issues are detected, you’ll likely need to replace the drive. If it’s just logical file system problems, once your data is safe, you can try reformatting the drive or running a lighter chkdsk /f scan first.

One quick note for future reference: using /f/r/x all at once is a heavy-duty scan, and drives with pre-existing issues can get stuck on /r because it keeps retrying unreadable sectors. Next time you have a slow drive, start with a simpler chkdsk /f first before moving to the more intensive /r flag—it’s faster and less likely to get stuck.

备注：内容来源于stack exchange，提问作者Ddoshi