Windows下Matlab向ARM设备部署因反斜杠报错求助

Windows系统下运行Matlab，将模型部署到ARM架构设备时，点击「Build Deploy Start」触发如下报错：

检测到框图名称中存在反斜杠''，在模块名称前应使用正斜杠'/'作为分隔符。

解决步骤 #

• 修正模型文件路径：Windows系统下Matlab支持正斜杠作为路径分隔符，把模型所在路径中的\全部替换为/，比如将C:\MyMatlabModels\ARMProject\demo.slx改为C:/MyMatlabModels/ARMProject/demo.slx，或者直接把模型移动到路径不含反斜杠的目录下。
• 检查模块命名：如果模型内的子系统、模块名称里包含反斜杠（例如命名为Sensor\Data），直接将\替换为/或下划线_等合法字符。
• 清理编译缓存：删除模型目录下自动生成的slprj和_ert_rtw文件夹，清除之前编译残留的错误路径信息，再重新执行部署操作。

错误堆栈信息 #

Error using codertarget.utils.invokeDownloader
The following error occurred during deployment to your hardware board:
Backslash '\' detected in block diagram name. Forward-slashes '/' should be used as the separator before block names.

Error in codertarget.tools.BuildHook/after_make

Error in coder.coverage.BuildHook.dispatch_after_make (line 347)
                after_make(hookH);

Error in coder.internal.ModelBuilder>i_buildProcedure (line 1599)
if ~isempty(lBuildHookHandles)

Error in coder.internal.ModelBuilder.make_rtw (line 119)
                [buildResult, mainObjFolder] = i_buildProcedure...

Error in build_target

Error in build_target

Error in build_standalone_rtw_target

Error in slbuild_private

Error in slbuild_private

Error in sl_feval

Error in slbuild

Error in slbuild

Error in slprivate

Error in coder.internal.toolstrip.HardwareBoardHandler/standaloneBuild (line 121)
            cbinfo.domain.buildModel(this.ModelHandle);

Error in codertarget.sltoolstrip.EmbeddedHardwareBoardContext/standaloneBuild (line 252)
            this.HardwareBoardHandler.standaloneBuild(cbinfo);

Error in codertarget.sltoolstrip.EmbeddedHardwareBoardContext/buildDeployStartHardwareBoardActionCBInternal (line 218)
            this.standaloneBuild(cbinfo, this.getSelectedBuildActionTS('Start'));

Error in coder.internal.toolstrip.HardwareBoardContext.buildDeployStartHardwareBoardActionCB (line 346)
                context.buildDeployStartHardwareBoardActionCBInternal( cbinfo ); - Show complete stack trace'

内容的提问来源于stack exchange，提问作者tsadigov